BS EN ISO 4126-6:2003 Safety devices for protection against excessive pressure. Application, selection and installation of bursting disc safety devices
BS EN ISO 4126-6 gives guidance on the application, selection and installation of bursting disc safety devices used to protect pressure equipment from excessive pressure and/or excessive vacuum.
Annex A provides a checklist for the information to be supplied by the purchaser to the manufacturer.
Annex B gives guidance on the replacement period of a bursting disc and annex C guidance on determining the mass flow rate, for single phase fluids, of a pressure relief system that contains a bursting disc safety device
Annex E is a non-mandatory procedure for establishing the flow resistance of a burst bursting disc assembly.
The requirements for the manufacture, inspection, testing, marking, certification and packaging of bursting disc safety devices are given in BS EN ISO 4126-2.
Contents of BS EN ISO 4126-6:
- Foreword
- Introduction
- Scope
- Normative references
- Terms and definitions
- Symbols and units
- Application
- Selection
- Selection of bursting disc safety devices
- Selection of the performance tolerance
- Installation
- General
- Location of bursting disc safety devices
- Installation of bursting disc safety devices
- Information to be supplied by the purchaser
- General
- Application details
- Bursting disc safety device operating details
- Installation details
- Special details
- Language
- Replacement bursting discs
- Guidelines for determining the replacement period of a bursting disc
- Introduction
- Bursting disc safety devices
- Replacement period
- Methods of determining the replacement period
- Pressure relief system discharge capacity
- General
- Simplified approach
- Comprehensive approach
- Derivation of compressibility factor Z
- Flow testing of bursting disc safety devices
- Scope
- Test requirements
- Method of testing
- Test procedure
- Determination of flow resistance factor KR
- Application of flow resistance factor KR
- Bibliography