Low-voltage switchgear and controlgear - Ancillary equipment. PCB terminal blocks for copper conductors
Low-voltage switchgear and controlgear - Ancillary equipment. PCB terminal blocks for copper conductors
  • Load image into Gallery viewer, Low-voltage switchgear and controlgear - Ancillary equipment. PCB terminal blocks for copper conductors
  • Load image into Gallery viewer, Low-voltage switchgear and controlgear - Ancillary equipment. PCB terminal blocks for copper conductors

Low-voltage switchgear and controlgear - Ancillary equipment. PCB terminal blocks for copper conductors

£218.00
£218.00
£109.00
Sold out

What is this standard about?

This part of IEC 60947-7 specifies requirements for PCB terminal blocks primarily intended for industrial or similar use.

Mounting and fixing on the printed circuit board is made by soldering, press-in or equivalent methods to provide electrical and mechanical connection between copper conductors and the printed circuit board.

This document applies to PCB terminal blocks intended to connect copper conductors, with or without special preparation, having a cross-section between 0,08 mm2 and 300 mm2 (AWG 28-600 kcmil), intended to be used in circuits of a rated voltage not exceeding 1 000 V AC up to 1 000 Hz or 1 500 V DC.

This document can be used as a guide for special types of PCB terminal blocks with components, such as disconnect units, integrated cartridge fuse-links and the like or with other dimensions of conductors.

If applicable, in this document the term “clamping unit” is used instead of “terminal”. This is taken into account in the case of references to IEC 60947-1.