BS EN ISO 19432:2008 Building construction machinery and equipment. Portable, hand-held internal combustion engine driven cut-off machines. Safety requirements and testing
BS EN ISO 19432 specifies safety requirements and their verification by testing for the design and construction of portable, hand-held, internal combustion engine driven, cut-off machines, intended to be used by a single operator in the cutting of construction materials, such as asphalt, concrete, stone and metal. It applies to machines designed for use with a rotating, bonded-abrasive and/or superabrasive (diamond) cut-off wheel having a maximum outside diameter of 406 mm, centre-mounted on, and driven by, a spindle shaft, where the top of the wheel rotates away from the operator.
BS EN ISO 19432 deals with all significant hazards related to the hand-held use of such machines. It specifies methods for the elimination or reduction of hazards arising from their use, as well as the type of information on safe working practices to be provided with the machines. Cut-off machines designed in accordance with this International Standard are intended to be used by persons who have read and understood the safety requirements given in the “instruction handbook” and who use the appropriate personal protective equipment (PPE).
Except for noise, environmental aspects are not considered by this BS EN ISO 19432; nor are cut-off wheel specifications given — for such specifications, see, for example, BS EN 12413 and BS EN 13236.
BS EN ISO 19432 does not apply to machines manufactured before the date of its publication.
Contents of BS EN ISO 19432:
- Foreword
- Introduction
- Scope
- Normative references
- Terms and definitions
- List of significant hazards
- Safety requirements and verification
- General
- Handles
- Speed
- Engine stopping device
- Throttle control
- Clutch
- Exhaust gases
- Cutting debris discharge
- Tank openings
- Protection against contact with parts under high voltage
- Transmission cover(s
- Protection against contact with hot parts
- Cut-off wheel guard
- Flange locking device
- Flange assembly
- Spindle diameter
- Special tools
- Noise
- Vibration
- Information for use
- Instruction handbook
- Markings
- Warnings
- Strength test of cut-off wheel guard
- Noise test code — Engineering method (grade 2 of accuracy)
- Measurement of vibration values at the handles
- Recommended pictorials and symbols
- Bibliography